Advantages of dry heating elements

[zihadhosenjm40]

Temperature regulators are used quite widely in everyday life, and they regulate the temperature literally everywhere: from a banal soldering iron to the microclimate in the house.

If you compare a dry design with a submersible one, the first one will have a lot of advantages:

no scale;
compact dimensions;
ease of maintenance;
excellent performance;
long service life;
no air pockets.
The main problem with all water heaters is scale. The reason for the formation of this layer is poor quality water and the fact that the surface of the heater comes into contact with liquid. From harder water, scale forms much faster, and the layer of lime is thicker and denser. Because of this phenomenon, the heating rate is significantly reduced, and the service life of even the most expensive water heater is noticeably reduced.

The dry design is reliably protected from such troubles, since spain mobile databaseis no contact with water, which means that scale cannot form.

Since most developers allocate catastrophically little space to the toilet and bathroom, the second important criterion for choosing a boiler is its size. The dry heating element has rather miniature dimensions in comparison with its "wet" relative. Since the dimensions of the water heater itself are significantly reduced, the manufacturer can reasonably install two or even three heating elements, which allows the consumer to heat water in just a few minutes if desired. Moreover, the consumer is not afraid of interruptions in the operation of one of the heaters, since he can always use the remaining ones.

High performance and easy maintenance
Since scale does not form on the dry element, the speed of obtaining hot water increases significantly. The water heater does not spend a lot of energy to perform its direct duty, which puts the dry heating element a step higher in comparison with the wet one.

Another important feature of the tubular element is the ease of repair. Despite the fact that such an element is durable, it can still fail. In order to repair the device, it is not necessary to completely dismantle the tank. It is enough to simply unscrew the protection and remove the element. After inspection and repair, the heating element is put back. According to a similar scheme, the tank is cleaned of scale every six months. The heating element is not affected, and only the inner wall of the tank is cleaned.