At this point, the installation of a warm floor

[zihadhosenjm40]

Then the connection point is insulated. Where the insulation is installed, as well as where the thermal sensor is attached to the film, thickenings will appear. They can complicate further installation of the floor covering.

To prevent this from happening, use a mounting knife to cut out recesses in the layer of thermal insulation material. This will eliminate the difference in height, and the surface of the film will become smooth again.

under linoleum can be considered complete; it remains to check the characteristics of the system before installing the floor covering. To do this, power is supplied to the film. First, you need to use an electrical tester to make sure that the insulation is reliable; you should check for voltage on each insulated section.

This diagram clearly shows the order of connecting new zealand mobile database film floor to the power supply. The thermostat should be installed in a place accessible for maintenance

After this, the degree of heating of each individual strip is checked. If there is no heat, or if individual sections are colder or hotter than others, then the installation was done incorrectly. Possible errors should be found and corrected.

Problems usually arise with such violations as laying the film strips not end-to-end, but overlapping, such a position of the heating material is unacceptable. You should also not cut the film too close to the copper busbar, this can cause insulation failure. Complete or partial lack of insulation is one of the most common causes of underfloor heating failure.

Features of laying linoleum
You will also need to prepare a base for the linoleum. First, a layer of polyethylene is laid over the infrared film. This material serves as a waterproofing material.