Features of laying laminate with a chamfer

[zihadhosenjm40]

Laminate with a chamfer cannot be laid in rooms where water may get on the floor. The recess increases the area of ​​wetting, which leads to deformation of the panels. The edges of the lamellas are treated with a water-repellent compound or laminated, or, in extreme cases, the cut is covered with wax or varnish. Therefore, water is colombia mobile database more dangerous for such a coating than for a regular one.
The presence of a chamfer makes the laminate more fragile; under mechanical stress, uneven edges can break, chips and cracks appear. Milling of edges is done for panels with a thickness of 10-12 mm, the same ones are rolled through rollers. A chamfer with a depth of 1-3 mm looks very modest compared to the dimensions of the board, so its presence does not affect the strength of the laminate in any way.
There is an opinion that the installation of laminate with a chamfer is more difficult. The locks and latches on all types of this material are identical and have a standard design. So this does not affect the quality and speed of installation.
There is only one drawback: models with decorated slat edges are more expensive.

If desired, you can combine simple laminate and laminate with decorative edging in one apartment, laying them in the most suitable rooms. The best are products of the 32nd and 33rd classes with reliable latches from well-known manufacturers. They form a strong, even coating without gaps. The design of the locking devices does not allow the panels to move apart for quite a long time, so the presence of a chamfer in such models does not play a significant role.

In principle, laying laminate with a chamfer is no different from the usual one.

Purchased laminate flooring must be kept in the room where it will be laid for 12 to 36 hours. This is due to the ability of laminated panels to change their parameters depending on the ambient temperature and humidity. This holding time is necessary so that the floors do not deform after laying.

The floor is prepared according to standard requirements for any covering. The finished surface must be hard, dry, clean, with acceptable height differences within 2 mm per 1 square meter of area.

The chamfer will hide minor irregularities, but with serious flaws, the uneven load on the floor will increase. This will lead to premature weakening of the locks and the appearance of gaps between the boards, the quality of the coating will deteriorate.